7
1. HANDLE ADJUSTMENT
A. Open the cam handle to release the handle locking gears.
B. Move the handle either up or down to a comfortable operating
height or the storage position.
C. Close the cam handle to lock the gears back into place.
2. MACHINE OPERATION
A. Fill the solution tank with clean water at a temperature not exceed-
ing 120°F. An operator can check the level of solution in the tank by
looking at the sight gauge on the side of the tank.
B. Add liquid detergent into the tank using the correct concentration
and manner specified by the manufacturer. Excess foam could dam-
age the vacuum motor, so be sure to use only the correct amount of
detergent.
C.
To ensure proper operation, 2 ounces of defoaming
liquid should be poured into the recovery tank before
each use. Defoaming liquid should only be used in the
recovery tank, never the solution tank.
If tank is removed from the machine for remote filling, be sure to
press it firmly on the base when returning it to the machine. This
is required to ensure that the solution valve on the bottom of the
tank properly engages with the solution port on the base.
D. Release the transport wheels by pressing on the foot lever. This will
lower the brush and squeegees onto the floor.
E. Plug the cord into a standard 120v outlet.
F. Turn on the Vacuum Switch
G. Turn on the Water Control Switch
H. Turn on the Brush Control Switch
OPERATION
E
F
G
H
A
D
