BETAFPV 01020010, User Manual

Page: 18 / 44

1 16
Switch SA: Arm/Disarm Quadcopter
● Release switch SA to arm
● Press switch SA to disarm
Switch SB
:
Quadcopter Level Calibration
● Button left unused without functions
● Pop-down Switch SB to perform Level Calibration
Switch SC
:
Speed Threshold of Quadcopter
● Pop-up switch SC and change to slow mode(SLOW)
● Pop-down switch SC and change to fast mode(FAST)
There are also 3 buttons at the bottom of the remote control radio transmitter.
Functions are as follows:
● Power Button: Push to the right to turn on, and Push to the left to turn off;
● BIND Button: Enter binding mode with a short press (active after the remote control
radio transmitter is powered on);
● SETUP Button: Enter joystick calibration mode with a short press (active after the
remote control radio transmitter is powered on);
Refer “Advanced Settings” for more infomation on binding or joystick callibration.
Switch SD: Change Video Transmitter (VTX) frequency
Press or release switch SD once. Then frequency will be automatically changed to the
next.
There are in total 8 frequencies.After switching to the last frequency(5866), frequency
will cycle to the first one (5733) and start again.
When quadcopter is flying in a low gear(SLOW), quadcopter body is slightly tilted front with angle 3-5
degrees, and movement speed is around 2m/s;
When quadcopter is flying in a high geat(FAST), quadcopter body is slightly tilted front with angle
5-10 degrees, and movement speed is around 3.5m/s.
The factory default frequencies are 5733/5752/5771/5790/5809/5828/5847/5866 in sequence.