4
C
h
ECKS AN
d
MAINTENANCE
36
GB
2
1
BLEEdING ThE fRONT BRAKE
To bleed air from the front brake circuit,
proceed as follows:
•
Remove the rubber cap
1
from the valve
2
.
•
Open the sump cap.
•
Place one end of a small transparent tube
into the valve
2
, and the other end inside
a container.
•
Pump with the brake lever 2/3 times and
keep the lever pressed.
•
Unscrew the valve and let the oil drain.
•
If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
•
Close the valve and release the lever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
•
Remove the tube.
•
Replace the rubber cap.
•
Close the oil reservoir cap.
Use the liquid indicated on page 16 in
the “Recommended lubricants and liquids”
table.
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the paintwork.
Wear appropriate protective clothing and protection gloves.
Keep liquid out of reach of children.
WARNING:
Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.
Summary of Contents for MINITRIAL LC
Page 28: ...28 GB ...
Page 48: ...48 GB ...
