Beta Motorcycles RR-S 350 EFI 2020, Owner'S Manual

Page: 52 / 91

4
C
HEC
KS AND MAINTENAN
CE
51
USA
BLEEDING THE FRONT BRAKE
To bleed air from the front brake circuit,
proceed as follows:
%
Remove the rubber cap
1
from the valve
2
.
%
Open the sump cap.
%
Place one end of a small transparent tube
into the valve
2
, and the other end inside
a container.
%
Pump with the brake lever 2/3 times and
keep the lever pressed.
%
Unscrew the valve and let the oil drain.
%
If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
%
Close the valve and release the lever.
NOTE:
during this procedure, continuously top up the brake pump thank to replace the oil
that is out flowing.
%
Remove the tube.
%
Replace the rubber cap.
%
Close the oil reservoir cap.
Use the liquid indicated on page 15 in the “Recommended lubricants and liquids”
table.
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the paintwork.
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
WARNING: Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.
1
2
M04_L0040