SAND FILTER
OWNER’S MANUAL
WARNING
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
READ AND FOLLOW ALL
INSTRUCTIONS
WARNING
-
TO REDUCE THE RISK OF INJURY -
do not permit
children to use this product unless they are closely supervised at all times.
WARNING
-
RISK OF ELECTRIC SHOCK -
Connect only to a
grounding type receptacle. This product is provided with a ground-fault circuit-interrupter.
If replacement of the plug is needed, use only identical replacement parts.
WARNING
-
The unit is provided with a ground-fault circuit-interrupter
(GFCI). To test the GFCI, push the test button. The GFCI should interrupt power.
Push the reset button. Power should be restored. If the GFCI fails to operate in this
manner, the GFCI is defective. If the GFCI interrupts power to the pump without the
test button being pushed, a ground current is flowing, indicating the possibility of an
electric shock. Do not use this pump. Disconnect the pump and have the problem
corrected by a qualified service representative before using.
CAUTION
-
To reduce the risk of electric shock the pool must be
installed no closer than 6 feet (1.8 m) from any electrical outlet. Do not place
portable appliances closer than 5 feet (1.5 m) from the pool.
DO NOT BURY CORD -
Locate cord to minimize abuse from lawn mowers, hedge
trimmers, and other equipment.
WARNING
-
To reduce the risk of electric shock, replace damaged cord
immediately.
WARNING
-
To reduce the risk of electric shock, do not use extension
cord to connect unit to electric supply; provide a properly located outlet.
CAUTION:
This pump is for use with storable pools only. Do not use with
permanently-installed pools. A storable pool is constructed so that it is capable of
being readily disassembled for storage and reassembled to its original integrity. A
permanently-installed pool is constructed in or on the ground or in a building such
that it cannot be readily disassembled for storage.
Please examine and verify all sand filter components are present before use. Notify
Bestway at the customer service address listed on this manual for any damaged or
missing parts at the time of purchase.
• THERMALLY PROTECTED MOTOR. CSA ENCLOSURE 3
• FOR USE WITH SWIMMING POOLS ONLY.
•
CAUTION:
TO ENSURE CONTINUED PROTECTION AGAINST
SHOCK HAZARD,USE ONLY IDENTICAL REPLACEMENT PARTS WHEN
SERVICING.
•
WARNING:
RISK OF ELECTRIC SHOCK. CONNECT ONLY TO A
GROUNDING TYPE RECEPTACLE.
•
CAUTION:
THIS PUMP IS FOR USE WITH STORABLE POOLS
ONLY - DO NOT USE WITH PERMANENTLY-INSTALLED POOLS.
•
CAUTION:
CONNECT ONLY TO GROUNDING TYPE RECEPTACLE
PROTECTED BY A CLASS A GROUND FAULT CIRCUIT INTERRUPTER.
•
CAUTION:
FOR CONTINUED PROTECTION AGAINST POSSIBLE
ELECTRIC SHOCK THIS UNIT IS TO BE MOUNTED TO THE BASE IN
ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS.
•
WARNING
-
RISK OF ELECTROCUTION
1) Connect Only To Properly Grounded Outlet. Do Not Remove Ground Pin.
2) Inspect Cord Before Using – Do Not Use If Cord Is Damaged.
3) Keep Ground-Fault Circuit-Interrupter Dry And Off The Ground.
4) Do Not Touch Plug With Wet Hands.
5) Double Insulated – When Servicing Use Only Identical Replacement Parts.
6) Read Instruction Manual Before Using.
DO NOT REMOVE THIS TAG
SAVE THESE INSTRUCTIONS.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
WARNING:
Any changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
SAFETY INSTRUCTIONS
2
GFCI WARNING
WARNING:
Risk of electric shock. The GFCI must be tested before
each use.
WARNING:
Do not use the pump if this test fails. For assistance,
please visit the support section on our website, www.bestwaycorp.com.
POOL SUCTION FITTING
INSTRUCTIONS
When installing and using this equipment, basic safety precautions shall always be
followed, including the following:
IMPORTANT SAFETY INSTRUCTIONS
READ, FOLLOW, AND UNDERSTAND
ALL INSTRUCTIONS AND WARNINGS.
- Any modification that increases the flow rate of the circulation system shall require
re-evaluation of the cover/grate and sump to ensure that the flow rating of the
Suction Outlet Fitting Assembly (SOFA) is not exceeded.
- Missing, broken, or cracked cover/grates, sumps, mud-frames, or any other SOFA
component shall be replaced before bathers are allowed to use the pool.
- Loose cover/grates shall be reattached before bathers are allowed to use the pool.
1. Replace suction fittings every 2 years.
2. The use of adhesives or other attachment methods that prevent access to suction
piping or SOFA components requiring periodic servicing is prohibited.
3. Refer to the following diagram for each SOFA
component part instructions:
4. - Any field modification made to a SOFA not
authorized by the manufacturer’s installation
instructions shall void the SOFA certification.
- No modification shall be made to a SOFA
structure or flow path unless the new
configuration has been certified as new SOFA.
- Cover/grates and all other SOFA components
shall be replaced at or before the end of their
service life and that service life begins the
month and year in which a SOFA component is
installed with or without water.
5. Winterizing instructions. Dry the suction fittings completely, and store the product
in a dry room at a storage temperature of 15
℃
~ 40
℃
.
6. Use the screwdriver (not included) to disassemble the suction fitting to clean or
service.
- Cover/grate, including fasteners, shall be observed for damage or tampering
each operational day.
- Missing, broken, or cracked cover/grates shall be replaced before bathers are
allowed to use the pool.
- Loose cover/grates and associated components shall be reattached before
bathers are allowed to use the pool.
- SOFA components and fastener receptacles shall be clean and free of debris or
obstructions during installation of cover/grate and fasteners.
- Remember to hand-check cover/grate for snugness to the sump/ frame after
installation.
7. Before using the product, please check the integrity of the head of the suction
fitting. If the product is broken, please do not use it.
8. - All SOFAs shall be installed in accordance with the manufacturer’s installation
instructions.
- No modification shall be made to a SOFA structure or flow path unless the new
configuration has been certified to the original SOFA.
- These SOFA-configuration specific flow ratings NOT be exceeded at any time
the pool is open to bathers.
- Cover/grates, when installed, shall not protrude more than 2 in. (51 mm) from
the finished surface of the pool in which the SOFA is installed
9.
Please research and download General Certificate of Conformity through
www.bestwaycorp.com
SAVE THESE INSTRUCTIONS
