3
S-S-004767
Section II: Barrier Locations
Barriers should be located so as to prohibit permanent structures, equipment or similar objects from being
used to climb the barriers.
Parts:
pool, 2 pairs of 3D goggles, 1 pack of crystals, repair patch.
Recommendations Regarding Placement of the Pool:
Do not install the pool on a slope or inclined surfaces, on soft or loose soil conditions (such as sand or
mud), or on an elevated surface such as a deck, platform or balcony, which may collapse under the
weight of the filled pool.
• It is essential the pool is set up on solid, level ground. If the pool is set up on uneven ground it can
cause collapse of the pool and flooding, causing serious personal injury and/or damage to personal
property. Setting up onuneven ground will void the warranty and service claims.
• Do not set pool up on driveways, decks, platforms, gravel or asphalt. Groundshould be firm enough to
withstand the pressure of the water. Mud, sand, soft/loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones and twigs.
• Check with your local city council for by-laws relating to fencing, barriers,lighting and safety require-
ments and ensure you comply with all laws.
INSTALLATION INSTRUCTIONS
Installation of POOL usually takes only 10 minutes for one person.
1. Find solid, level ground and clear it of debris.
ATTENTION:
Do not set up the pool under cables or under trees.
2. Take the pool out of package with care.
3. Spread out the pool and make sure the pool is right side up.
4. Open the safety valves and inflate with an air pump (pump is not included in this product), close the
valves after inflation.
ATTENTION:
Do not over inflate.
5. Begin to fill, once pool floor is slightly covered, smooth all wrinkles. Start at the center of pool and move
to the outside.
6. Slowly fill the pool to a proper water lever, if there is a fill line, reach but do not exceed the fill line on the
pool's interior. Please kindly pay close attention not to over fill the pool for security reasons.
WARNING:
Do not leave pool unattended while filling with water.
DISASSEMBLY AND CLEANING
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. For the inflatable pool, deflate all the air chambers, at the same time push down the wall of the pool to
release the water. Make sure release all the water in 20 minutes.
NOTE:
Drain by adult only!
ATTENTION:
Do not leave the drained pool outside.
3. Open the safety valve and squeeze the valve at its base to deflate.
4. After deflation, use a damp cloth to clean.
MAINTENANCE
WARNING:
If you do not adhere to the maintenance guidelines covered herein, your health might be at
risk, especially that of your children.
1. Replace the pool water regularly; unclean water is harmful to user’s health.
2. Please contact your local retailer to obtain chemicals to treat the water in your pool. Be sure to follow
the chemical manufacture’s instructions.
3. Proper maintenance can maximize life of your pool.
4. See packaging for water capacity.
REPAIR
If a chamber is damaged, use the provided repair patch.
1. Completely deflate the product.
2. Clean and dry the damaged area.
3. Apply the provided repair patch and smooth out any air bubbles.
STORAGE
1. Make sure all water is drained from the pool. Once pool is completely dry, put the folded pool into the
package.
2. Store in a cool, dry place and out of children’s reach.
