the scale the lower the temperature.
""'""
2. Press
"REBOIL"
to heat water. At this moment
the light will change from
"KEEP WARM"
to
,,HEATING".
3. In order to cool water first press the cold water
button lever and then
"COLD POWER"
button.
CAUTION:
lf it is not necessary, do not press
"COLD POWER"
button. You can do it again after 3
minutes 3 min. (in order to protect the compressor).
Cold water temperature is sei within the range 4-12
degrees C.
You can regulate lhe temperature by the use
.....
-
-
-
�
of a controller mounted at the back side of
Waier Distributor. The higher the value on
10. WATER DISTRIBUTO
SERVICE AND
MAINTENANCE
ml)
WATER DISTRIBUTOR CLEANING
1. Make sure Waier Distributor is unplugged
before you start cleaning.
2. Remove the top cover, cool water tank
cover and hot water tank cover.
3. By the use of cold, cool and hol water
button levers release the remaining water.
4. In order to empty the cold water tank remove the drain plug from the water tank,
which is is located at the back side of the Waier Distributor.
5. Clean the hol and cool water tanks ONL Y by the use of disinfecting substances
admitted for food industry by appropriate authorities.
CAUTION: DO NOT TILT THE WATER DISTRIBUTOR TO THE SIDES DURING CLFANING. IT
MA Y CAUSF SFVFRF SYSTEM DAMAGFS HY FLOODING IT WITII
WATFR. AFTFR YOU HAVF CLFANFD OR INSTALLFD THF SYSTEM,
WAIT 10 MINUTFS HEH)RF YOU PRFSS "COLD WAIER" HUTff)N.
�
ß1E
PREFIL TERS EXCHANGE --
CAUTION: THE PRODUCER DOES NOT TAKE REPONSIBILITY FOR INSTALLING CARTRIDGES,
MEMBRANES AND OTHER RERVERSE OSMOSIS EQUIPMENT ELEMENTS DIFFERENT
THAN THOSE PROVIDED IN THE SET. THE PRODUCER IS NOT LIABLE FOR ANY DAMAGES
CAUSED TO THE SYSTEMS DUE TO IMPROPER INSTALLATION OR USAGE OF WATER
TREATMENT ELEMENTS.
15
