Trektop™ – Installation Instructions
Rev. C 0209
56801 / 56802 pg. 3
Locate the Left and Right Door Surrounds and the Left
and Right Door Surround Brackets in the parts kit.
Orient the Door Surround Brackets with the long tab
toward the inside. Install the brackets on the Door
Surrounds using two #10 Phillips Head Self Tapping
Screws for each bracket.
Install Door Surround Brackets
on Door Surrounds
Door Surround
Door
Surround
Bracket
#10 Phillips Head
Self Tapping
Screws
Orient the Left and Right Door
Surround Assemblies on the
vehicle with the brackets toward
the inside. Align the slot in the
bracket with the hole in the bot-
tom of the Horizontal Support
Bar. Install a 1/4-20 x 2-1/4"
Screw with a 5/16" Washer
through the top of the Horizon-
tal Support Bar into the Door
Surround Bracket. Install a 1/4-
20 Locknut on the screw. Close
the door to check the seal and
adjust the bracket if necessary
for a good seal. Repeat on the
other side of the vehicle.
Install Door Surround
Assemblies
1/4-20 x 2-1/4"
Screw
5/16"
Washer
Door Surround
Assembly
Door Surround
Assembly
Door Surround
Bracket
Horizontal
Support Bar
Thread Screw
into Bracket
Horizontal
Support Bar
Door Surround
Bracket
Driver's Side
Shown
Door
Surround
5/16" Washer
5/16-18 Tapping
Plate - under ledge
5/16-18 x 1 Phillips
Head Bolt
Secure the bottom of the Door Surround to the ve-
hicle using a 5/16-18 x 1 Phillips Head Bolt, a 5/16"
Washer and a 5/16-18 Tapping Plate. Place the
Tapping Plate under the ledge, aligning the hole in
the plate with the hole in the vehicle and install the
screw and washer from the top. Test the door seal
again and adjust the bottom of the Door Surround if
necessary for a good seal.
Install Door Surround
Assemblies
1/4-20 Locknut
1/4-20 Locknut
