Rev. A 4.19.07
81705 pg. 5
TrailMax™ DVD Console Installation Instructions
Thread Wire
through Dash
Pull the panel along the side of the
dash away.
Route the wiring harness from the
sport bar down along the A-Pillar and
under the dash into the footwell.
Wiring Harness
Continue to route the wiring
harness along the route
of the other bundled wires
through grommet in the
fi rewall and into the engine
compartment.
Thread Wiring Harness through Fire Wall
Thread Wire
through Grommet
Press the Spade Connector on the end of the
power line on the Wiring Harness.
Install Spade Connector
Spade Connector
Power Line
from Harness
Route the Wiring Harness along the engine compart-
ment to the accessory connection point for power
source when the key is on (Fuse CB1 Ignition off
accessory power) in the fuse box. Install the Brass
Fuse Connector. Connect the Spade Connector to
the Brass Fuse Connector.
Connect the ground on the Wiring Harness to the
ground off the battery.
Reconnect the battery.
Connect Spade
Connector to Brass
Fuse Connector
Install Brass Fuse Connector
Install Brass Fuse
Connector
Connect Ground to
the Ground off the
Battery
Disconnect the battery before
installing the Fuse Connector.
