PowerBoard – Installation Instructions
Rev. K 1011
75134 pg. 3
Install M8 U-Nuts
Install Linkages
Remove the cable from the rear support bracket
and use the Hex Bolt, 8mm Washer and Nylock Nut
to install the Brake Cable Bracket on the front of the
support bracket. Reinstall the parking brake cable
and remove vise-grips.
Disengage parking brake.
Pull parking brake cable to the rear from the forward
support bracket to create slack in the cable. Secure
the cable slack with vise-grips.
Install Brake Cable Bracket
Loosen Parking Brake Cable
Counting from the front, locate the second (2nd) and last set of mounting holes
on the inner sill on the driver’s side. Use an M8-1.25 x 40 Hex Bolt and an 8mm
Washer to install an M8 U-Nut on each side of each hole. Do not tighten the bolts
at this time.
View from under vehicle
Front
Rear
Driver’s Side
M8
U-Nuts
8mm
Washers
M8-1.25 x 40
Hex Bolts
Idler
Linkage
Position
Motor Linkage
Position
Install an Idler Linkage in the
rear hole and a Motor Linkage in
the front hole. Slip the notches
in the Linkages under the bolts
and washers installed in Step
One. Secure the bottom of the
Linkages with two M10-1.75 x
25 Button Head Screws and two
10mm Washers.
Do not tighten the bolts at this
time.
Repeat Steps One and Two
on the passenger side of the
vehicle.
Idler
Linkage
Driver’s Side
M10-1.75 x 25
Button Head
Screws
10mm
Washers
Remove the fuse from the
Wiring Harness.
Remove the fuse from the Wiring Harness. Failure
to do so could result in severe electrical shock which
could harm the installer and/or damage the vehicle.
Remove Fuse from
Wiring Harness
Nylock
Nut
Brake Cable
Bracket
Hex
Bolt
8mm
Washer
