background image

PowerBoard – Installation Instructions

Rev. K 1011

75134 pg. 8

LIMITED WARRANTY

We warrant our product to be free from defects in material and workmanship, for the terms 
specifi ed below, provided there has been normal use and proper maintenance. This warranty 
applies to the original purchaser only. All remedies under this warranty are limited to the repair 
or replacement of any item or items found by the factory to be defective within the time period 
specifi ed.  If you have a warranty claim, fi rst you must call our factory at the number below 
for instructions. You must retain proof of purchase and submit a copy with any items returned 
for warranty work. Upon completion of warranty work, if any, we will return the repaired or 
replaced item or items to you freight prepaid. Damage to our products caused by accidents, 
fi re, vandalism, negligence, misinstallation, misuse, Acts of God, or by defective parts not 
manufactured by us, is not covered under this warranty.  

THE WARRANTY TIME PERIOD IS AS FOLLOWS FOR ALL PowerBoards MANUFACTURED 
BY OUR COMPANY: THREE YEARS / 36,000 MILES FROM DATE OF PURCHASE.

ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A 
PARTICULAR PURPOSE CREATED HEREBY ARE LIMITED IN DURATION TO THE SAME 
DURATION AND SCOPE AS THE EXPRESS WRITTEN WARRANTY. OUR COMPANY SHALL 
NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGE.

Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or 
limitation of incidental or consequential damages, so the above limitations or exclusions may 
not apply to you. This warranty gives you specifi c legal rights, and you may also have other 
rights which vary from state to state.

For further information or request for warranty work, please contact:
Bestop Inc. Customer Service
Toll-Free: (800)845-3567
Main: (303)465-1755
E-mail: [email protected]
Website: www.Bestop.com

Linkage Component Identifi cation

Motor Gear 
Shaft

Motor 
Mounting 
Boss

Mounting 
Tab

Upper 
Casting

Outer 
Link

Inner 
Link

Lower 
Casting

Mounting 
Foot

Motor 
Linkage

Idler 
Linkage

Pivot 
Leg

Summary of Contents for PowerBoard 75134-15









Reviews: