B-8
Wire Feeder Connection
To connect the wire feeder to the power source Magster 380 or 450 you should use
the combined cable (see chapter “Accessories”) and do the following:
Connect the combined cable to the socket marked by
.
Connect the control cable to the socket marked by
To connect the wire feeder to the semi power source Magster 450W you should use
the combined cable (see chapter “Accessories”) and do the following:
Connect the combined cable to the socket marked by
.
Connect the control cable to the socket marked by
.
Disconnect the hose, which closes the circuit of the water cooling system
and connect hoses to the welding source and wire feeder according to
colour marks (the blue hose to the socket with blue bordering).
Wire diagram of the welding source and wire feeder is shown in the chapter “Wiring
Diagrams”.
Ground Cable Connecting
Connect the ground cable to one of the two sockets
, additionally marked by:
: high inductance output socket.
: low inductance output socket.
Shielding Gas Connection
To connect shielding gas you should do the following:
After placing the gas cylinder on the gas cylinder mount, protect it from
overturn with the chain.
Take off the cap over the safety valve of the shielding gas cylinder.
Install the gas regulator on the gas cylinder.
Connect the shielding gas cylinder to the wire feeder with the gas hose of
the combined cable, using clamping band.
Welding with CO
2
as shielding gas, you should use the gas heater which
can be supplied from the socket on the rear panel of the welder.
Final Actions
Connect the ground cable to the work piece with the work clamp.
Connect the shielding gas cylinder to the shielding gas input through the gas
regulator.
Insert the plug of the power input cable of the welder into the mains socket.
Switch on the power source with the power switch. It is indicated by lighting
up of the switch button.
Based on the seam kind, join type and material thickness of the work piece,
chose correct welding settings with the welding voltage switch and wire
feeder controls.
Obeying the appropriate rules, begin to weld.
Summary of Contents for MAGSTER 380
