BESTEK NSP-10H6, User Manual

Page: 17 / 41

17
(4) Add the 3.5” Hard Drive: As illustrated below, please have the 3.5” Hard Drive assembled with this Hard Drive
bracket, leaving the Hard Drive I/O at the end as in the figure below, and add in the suggested numeric
sequence the four screws enclosed in the accessory screw bag, for a perfect and firm Hard Drive subset.
(5) Add the two 2.5” Hard Drives: As illustrated below, please have the two 2.5” Hard Drive assembled with the two
smaller L ‐ brackets, leaving the Hard Drive I/O at either end as the brackets are symmentrically designed, and
add the eight screws enclosed in the accessory screw bag, for a perfect and firm Hard Drive subset. In case only
one 2.5” Hard Drive is to be installed, add this Hard Drive on either top or bottom position to make the subset.
Attach the finished 2.5” subset into the Hard Drive bracket, ensuring HDD Drive I/O are at the similar position as
in the 3.5” Hard Drive section, and add the four screws from the top to complete the job.

(6) Restore this Hard Drive subset back to the chassis, assure the Hard Drive I/O side face to the power supply unit,
and add the four screws back to position.
(7) Add SATA signal cable and SATA power cable to complete the work.