Escape Series Walk-in Bathtub
I N S T A L L A T I O N I N S T R U C T I O N S
( C O N T I N U E D )
4
STEP 2:
PREPARE THE BATHTUB
1. Install the plumbing rough-in on the deck (unless it was factory installed).
2. Install the waste/overflow assembly and connect the door drain fitting to the drain.
Front skirt panel may be removed during installation to prevent damage and
make handling more convenient. Make sure panel is stored in a safe place to
avoid damage, as it must be reattached after final installation.
(continued on page 5)
Figure 4
Install the
waste/overflow
and door drain fitting
2
Install the valve rough-in
(unless it is factory installed)
1
Corner Installation
Figure 3
Install the valve rough-in
(unless it is factory installed)
1
Install the
waste/overflow
and door drain fitting
2
Alcove Installation
Deck extension
(optional)
Front skirt panel is held on
by magnets and can be
removed during installation
End panel (optional)
Front skirt panel is held on
by magnets and can be
removed during installation
