4
8. Attach a Leg Connector-Outer (P3) to the top Leg (P2A) using two
CS Screws (A) as shown in illustration #2. The top of the leg has a plastic tude
closure cap in it. Tighten CS Screws (A) using Allen Wrench (I).
A
F
D
P3
9. Place a Lock Washer (D) on the threaded stem of a Locking Caster (F) and screw it into the
bottom of the Leg (P2A). Use Caster Wrench (H) to tighten caster.
10. Attach a Leg Connector-Inner (P4) to a Leg (P2B) using two CS Screws (A) to secure. Make
sure the threaded hole in the side of the Leg Connector-Inner is positioned as shown in
illustration #2. Tighten screws with Allen Wrench.
11. Place A Lock Washer (D) on the threaded stem of Locking Caster (E) and screw it into the
bottom of the second Leg (P2B). Tighten with Caster Wrench (H).
12. Slide the Leg Connector-Inner that is on the Front Leg up and into the Leg Connector Outer
that is attached to the Rear Leg.
E
H
Left Front Leg
This will be a
Left Rear Leg
This will be a
P4
A
illustration #2
illustration #2
Detail
P2A
P2B
I
D
Make sure
both of these
pins are pointing
in this direction
Make sure these
holes are on the
same side and
facing the same
direction that the
pins are pointing.
