3
Assembly Instructions
1. Read instructions throughly before starting the assembly process.
2. Layout and identify the parts and hardware.
3. Attach a Leg Connector-Inner (P4) to the top Leg (P2A) using two
CS Screws (A) as shown in illustration #1. The top of the leg has a plastic tude
closure cap in it. Tighten CS Screws (A) using Allen Wrench (I).
A
H
E
D
P4
4. Place a Lock Washer (D) on the threaded stem of a Locking Caster (E) and screw it into the
bottom of Leg (P2A). Use Caster Wrench (H) to tighten caster.
5. Attach a Leg Connector-Outer (P3) to Leg (P2B) using two CS Screws (A) to secure each.
Make sure the threaded hole in the side of the Leg Connector-Outer is positioned as shown in
illustration #1. Tighten screws with Allen Wrench (I).
6. Place A Lock Washer (D) on the threaded stem of Caster (F) and screw it into the bottom of
Leg (P2A). Tighten with Caster Wrench (H).
7. Slide the Leg Connector-Inner that is on the Rear Leg up and into the Leg Connector-
Outer that is attched to the Front Leg.
F
D
Right Rear Leg
This will be a
Right Front Leg
This will be a
P3
A
illustration #1
illustration #1
Detail
P2A
P2B
I
Make sure
both of these
pins are pointing
in this direction
Make sure these
holes are on the
same side and
facing the same
direction that the
pins are pointing.
