Step 18
Install Gable
& Door Trim
1.
Locate (2) two 1x4-6' trim boards. Cut each
to fit against back of front gable trim and
install on the side walls.
1x4 Gable Trim
1x4 Fascia
Step 19
Finish Side Wall Trim
1.
Install a keystone and gable trim
under the roof sheathing as done
in Step 13.
82-1/2” Long
1x4 Gable Trim
Step 17
Install Door Flashing
3-1/2"x5"
Flashing
1.
Locate in the pocket door box (2) two 3-1/2"
x 5" metal flashing and bend along width to
90 degrees. Install at each corner of the door
opening. These will be covered in the next
steps.
2.
Install the galv. door sill over flashing in the
center of the door opening.
Use 1-1/4" pan head screws along the front
edge.
Galv. Sill
79-5/8"
Long Jamb
1x4 Cut
to Fit
2.
Install a 3-7/8" x 72" primed jamb
material on the top of the door
opening, flush with the front wall
OSB. Use 6d galv. nails.
3.
Locate (2) two 3-7/8" x 79-5/8"
primed jamb material and install on
the sides of the door opening, flush
with the front wall siding.
4.
Measure from bottom of header to bottom
of siding. Cut (2) two 84" long 1x4s to this
length and install on sides of door openting
flush with bottom of header and door jamb.
5.
Locate an 81-3/4" long 1x4 trim board, this
board has angle cuts on both ends. Cut this
board to fit flush with outside of vertical
door trim. Install above door.
