X
X
X
X
X
X
X
X
X
X
X
X
Step 4
Assemble Front Wall Frame
1.
Cut (2) two 2x4-12' boards to a length of 144" for wall plates. Position the boards together and
indicate with 'X' Marks where the wall studs will be located.
3.
Remove (2) two 2x4s screwed
to the pallet. Cut both to a
length of 78-1/2" and install
as header supports where
shown. Nail to studs with 10d
sinkers.
4.
Install the door header on the
2x4 header supports. Nail to
the stud with 10d sinkers.
5.
Measure space between header
and top plate. Cut (4) four
pieces to this length from a
pre-cut stud. Equally space the
(2) center blocks. Nail through
top plate and toenail to header.
Use 10d sinkers.
Install these Studs Centered
2.
Install (6) six pre-cut wall studs between the wall plates where shown.
33"
33"
8.
Install a full width siding panel on the right side of
the wall panel. Cut siding as previously instructed.
6.
Install a full width siding panel with the 'LAP' edge flush with left side of wall frame and with
top plate. Before installing siding, cut the siding flush with the side of the door opening and
the bottom of header.
7.
Install a 20"x48" siding panel above the door opening flush with top plate. Cut siding flush
with the bottom of the door header.
'LAP' Edge Flush
Flush
Cut Siding Flush
2x8 Door Header
78-1/2" Header Support
nail
nail
2x4 Blocks
72" Between Header Supports
