BEST ACCESS SYSTEMS 34HW, Service Manual, Page: 150 / 228

Additional Service and Maintenance for IDH Max Locks
6–10 W Series Service Manual
Reinstalling the reader circuit board assembly
1. For locks with a magnetic stripe swipe card reader , connect the
reader harness to the reader circuit board and position the circuit
board in the outside escutcheon.
For locks with a proximity card reader , align the connectors on
the back of the reader circuit board assembly with the reader pins.
Press the board into place.
2. Loosely install the two reader electronics mounting screws.
3. Position the harness clamp under the left reader electronics
mounting screw. Make sure the reader wire harness is positioned
properly under the harness clamp. Tighten the screws.
4. Remove the backing from the adhesive tape and apply the tape to
the back of the outside escutcheon.
5. Press the sounder in place on the tape.
6. Peel away the protective backing from the edge of the escutcheon
gasket and slide the gasket onto the upper escutcheon post. Press
the gasket into place on the edge of the escutcheon so the reader
circuit board is covered.
7. Connect the reader wire harness to the control electronics circuit
board. For mortise instructions, see
Task E. To connect the reader
wire harness: on page 4–17 . For cylindrical instructions, see
Tighten the RQE rose liner on the door with the through-bolts. on
page 5–12
.
8. Reinstall the outside escutcheon. For mortise instructions, see
Task F. To secure the escutcheons and complete the connections:
on page 4–20 . For cylindrical instructions, see Task G. To secure the
escutcheons and complete the connections: on page 5–15 .
9. Reinstall the inside lever/knob. For mortise instructions,
see
Task G. To reinstall the inside and outside levers/knobs:
on
page 4–21 . For cylindrical instructions, see Task H. To reinstall the
inside and outside levers/knobs: on page 5–16 .
10. Reinstall the core and throw member. For mortise instructions, see
Task H. To reinstall the core (EEL and EEU only): on page 4–23 .
For cylindrical instructions, see Task I. To reinstall the core and
throw member: on page 5–17 .
11. Making sure that the access door does not pinch any wires , insert
the tabs of the access door into its mating slots and swing the door
closed. Use the appropriate bit driver to secure the access door with
the security screw. Tighten firmly.