BEST ACCESS SYSTEMS 34HW, Service Manual, Page: 125 / 228

Service and Maintenance for Cylindrical Locks
W Series Service Manual 5–15
4. From the inside of the door, feed the sensor and solenoid wire
harness from the control electronics circuit board, as well as the
sensor wires and the solenoid wire, through the large opening in the
inside escutcheon.
Caution
When routing the reader wire harness, make sure the reader wire
harness is not rubbed across any sharp edges or over any surface
that could damage its sleeving or wire insulation.
Task G. To secure the escutcheons and complete the connections:
1. Position the inside and outside escutcheons onto the door.
2.
Making sure that the escutcheon does not pinch the wires
, secure
the escutcheons to the door—but do not tighten. Use the upper
escutcheon screw at the top escutcheon hole and the lower
escutcheon screw at the bottom escutcheon hole.
Caution
When routing the sensor and solenoid wire harness, the sensor wires,
and the solenoid wires, make sure the wires are not rubbed across
any sharp edges or over any surface that could damage their sleeving
or wire insulation.
Figure 5.16 Connecting the reader wire harness to the control electronics circuit
board
Inside of door
Reader wire harness
connector
Sensor wires and
solenoid wire
Inside escutcheon
Large opening
Sensor and solenoid
wire harness
Control electronics
circuit board
Bushings