BEST ACCESS SYSTEMS 34HW, Service Manual, Page: 143 / 228

Additional Service and Maintenance for IDH Max Locks
W Series Service Manual 6–3
Reinstalling the sensor and solenoid wire harness
1. Connect the sensor and solenoid wire harness to the control
electronics circuit board.
2. Make the connections and reinstall the inside escutcheon. For
mortise instructions, see
Task F. To secure the escutcheons and
complete the connections: on page 4–20 . For cylindrical
instructions, see Task G. To secure the escutcheons and complete
the connections:
on page 5–15
.
3. Reinstall the inside lever/knob. For mortise instructions,
see Task G. To reinstall the inside and outside levers/knobs: on
page 4–21 . For cylindrical instructions, see Task H. To reinstall the
inside and outside levers/knobs: on page 5–16 .
4. Reinstall the core and throw member. For mortise instructions, see
Task H. To reinstall the core (EEL and EEU only):
on page 4–23 .
For cylindrical instructions, see Task I. To reinstall the core and
throw member: on page 5–17 .
5. Making sure that the access door does not pinch any wires , insert
the tabs of the access door into its mating slots and swing the door
closed. Use the appropriate bit driver to secure the access door with
the security screw. Tighten firmly.
Removing and
reinstalling the
reader wire harness
Removing the reader wire harness
To replace a reader wire harness for the magnetic stripe swipe or
proximity card reader
, a new outside escutcheon gasket (A60725) is
needed.
1. Remove the core and throw member. For mortise instructions, see
Task A. To remove the core: on page 4–3 . For cylindrical
instructions, see Task A. To remove the core and throw member:
on page 5–3 .
2. Remove the inside lever/knob. For mortise instructions,
see Task B. To remove the inside and outside levers/knobs: on
page 4–4 . For cylindrical instructions, see Task B2. To remove the
plain lever/knob:
on page 5–4
.
3. Use the appropriate bit driver to remove the security screw from the
access door. Open the access door and remove it from the inside
escutcheon.
4. Remove the outside escutcheon from the door. For mortise
instructions, see Task D. To disconnect the connections and
remove the outside escutcheon:
on page 4–6 . For cylindrical
instructions, see Task D. To disconnect the connections and
remove the outside escutcheon: on page 5–4 .
5. For magnetic stripe swipe or proximity card readers, remove the
escutcheon gasket from the outside escutcheon and discard the
gasket.