20
5.2.5 Laser Beam Alignment: between the second and third reflective mirror:
Step 2:
Move the laser head to the furthest
point between the 2nd and 3rd mirror and press
the button ‘Pulse’. Check if the mark matches
the previous one (they overlap each other);
otherwise, tighten the three screws as indicated
in the previous section.
(5.2.1 Screw adjustments
to guide the path of the laser beam).
Step 3:
After the marks match, move the laser
head from right to left and make new marks by
pressing the button ‘Pulse’ to verify that they
remain one over the other.
Final mark between the 2nd and 3rd mirror:
Respectively, from the second reflective mirror
up to the third, the laser should fit into the central
part of the mirror. If not, calibrate the laser again
until it hits the center of the third reflective mirror.
Note:
the screws on the first mirror already
are calibrated. In this step the screws to
be manipulated are those from the
2nd
REFLECTIVE MIRROR.
Step 1:
Place the acrylic piece on the third
reflective mirror. The laser head must remain at
the minimum distance between the 2nd and 3rd
reflective mirror. Press the ‘Pulse’ button and
check the position of the laser mark.
In case the mark from the
step 3
is placed:
To the left:
loosen the screw
#2
Up:
loosen the screw
#1
Up left diagonally:
tight the screw
#3
To the right:
tight the screw
#2
Down:
tight
the
screw
#1
Down right diagonally:
loosen the screw
#3
Make these adjustments until both marks are
located one above the other.
