16
Height adjustment of shoulder belts
The shoulder belts can be set in
three levels.
1.
The correct level is the same height as
the child’s shoulders or higher.
2.
Height can be adjusted by releasing the
height adjustment device behind the
seat back, raising/lowering it and
clicking
it in the correct selected position. See fig. 28a
3.
Adjust the belts on the front of the seat
Fig. 28a
to the same height as point 2, see fig. 28b
4.
Tighten the belts by pulling them towards you
and in this way straighten them out
inside the construction.
Removal/fitting of cover
Fig.28b
1.
To remove the cover, the child seat
hip belt must be released at both sides.
See red arrow.
2.
Raise the seat part of the cover and
unhook both belts from the metal
hooks in the bottom of the seat.
See fig. 29
3.
When fitting the cover, start by hooking
the hip belts to the hooks in the bottom
of the seat. See fig. 29. See red arrow
4.
To bring the cover under the rear part
of the sidewall, turn it inside out and
guide it under the sidewall before
straightening it out.
5.
Then attach the cover to the hooks on
the front lower edge of the seat.
Fig. 29
6.
IIt is
very important
to hook the belts
on correctly and that the belt loop is
Washing the cover
in position round the metal brace before
refitting the cover.
If any problems arise, contact
your BeSafe dealer.
T-0427 iZi COMBI X1 N F GB Mont 16-02-06 09:24 Side 16
