Berthoud BOXER II 3000 A, Manual

Page: 33 / 48

33
MAINTENANCE AFTER OPERATION
WINTER STORAGE
- It is also important to rinse the sprayer on the outside as well as the tractor. This cleaning is also essential
on the same day between two applications of different products.
PROCEDURE
- Remove the filters.
- Fill the tank to 20 % full with water and add detergent (All Clear, reference 778.886, 5 liters can).
- Operate the sprayer for a short period.
- Rock the sprayer by moving forward and backward with a view to agitation water into the tank.
- Leave mixture to act for 12 to 24 hours.
- Start the agitation and moving forward and backward several times, then empty using the draining valve .
- Put some clean water into the tank.
- Unscrew a nozzle, at the end of each spraying section.
- Rinse with clean water.
- Remove all nozzles and filters, and clean them.
- Reassemble.
- See chapter "Servicing the boom" (page 72).
- The sprayer should be wintered in a clean condition (see above).
- Completely drain the liquid circuit, making sure that the pump is not operated too long without water (2
minutes maximum).
- Grease all mechanical parts that can be rust.
- Deoxidize the contacts on the plugs (BERTHOUD reference 765.065 the KF F2 aerosol).
- Clean the outside of the machine. Paint the mechanical parts exposed (BERTHOUD reference 769.077 for
the blue paint aerosol or 778.890 for the green paint aerosol).
- Garage the machine out of the sunlight and protected against bad weather and on flat, load-bearing ground.