16
E
E
E
E
E
BERTAZZONI
A4
BERTAZZONI
A4
BERTAZZONI
A4
STEP-BY-STEP INSTALLATION GUIDE
OUTSIDE BACK EXHAUST
You need to cut a 12" x 4" (30.5 x 10.2 cm) rectangular
opening in the Rear Wall Template for outside exhaust.
1.
Read the instructions on the Rear Wall Template.
2.
Tape it to the rear wall, lining up with the holes previously
drilled for holes A and B in the wall plate.
3.
Cut the opening, following the instructions of the Rear
Wall Template.
B2.
ATTACH MOUNTING PLATE TO THE WALL
Attach the mounting plate to the wall using the wing nuts and
toggle bolts. At least one lag screw must be used to attach
the mounting plate to a wall stud.
1.
Insert the toggle bolts into the mounting plate through the
holes designed to go into drywall and attach the wing nuts
to
3
⁄
4
" (1.9 cm) onto each toggle bolt.
2.
Place the mounting plate against the wall and insert the
wing nuts into the holes in the wall to mount the plate.
CAUTION
Be careful to avoid pinching fingers between
the back of the mounting plate and the wall.
3.
Tighten all bolts. Pull the mounting plate away from the
wall to help tighten the bolts.
TO USE TOGGLE BOLT
Mounting
plate
Wall
Toggle
Bolt
Wing nut
Bolt end
Spacing for toggles more
than wall thickness
5
/
8
"
B3.
USE TOP CABINET TEMPLATE FOR PREPARATION
OF TOP CABINET
You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
• Read the instructions on the Top Cabinet Template.
• Tape it underneath the top cabinet bottom.
• Drill the holes, following the instructions on the Top
Cabinet Template.
CAUTION
Wear safety goggles when drilling holes in
the cabinet bottom.
B4.
ADAPT MICROWAVE BLOWER FOR OUTSIDE REAR
Summary of Contents for KOTR24MXE
Page 22: ......
