38
pushing in the bottom.
Back liners (60cm and 90cm ovens only)
-
Place hole in centre, bottom of the liner over the hole below the fan at the
Back of the oven.
-
Screw into position.
Cleaning stay clean We recommend that side shelf runners, telescopic runners and shelves are
liners
by hand.
removed prior to cleaning, the stay clean liners and the door and floor are cleaned
-
After cooking (especially after roasting) remove all trays and shelves.
Heat the oven
to maximum temperature for 15 - 20 minutes to allow the stains to
catalyse (true fan or fan assisted functions).
-
If the oven is heavily soiled, allow the oven to cool before cleaning the splashes
with a damp sponge. Then heat the oven for two hours at maximum
temperature.
-
Repeat the cycle if difficult marks have not been removed.
-
Periodically, the side panels can be removed from the oven and washed with
lukewarm soapy water before drying with a soft cloth. Before refitting the
panels, clean the enamel interior.
Enamelled surfaces
Do not allow vinegar, wine, coffee, milk, salt water or fruit juices to remain in contact
with enamelled surfaces for prolonged periods as they may stain or discolour the
surface.
For light soiling wipe with a soft cloth, using warm water and washing up liquid. For
heavier soiling use a cream cleaner and a nylon scourer.
Oven cleaning products can be used according to the manufacturer's directions but
care should be taken that they do not come in contact with any stainless steel,
chrome, coloured or alloy parts of the cooker or the door seals and elements.
Side shelf runners, shelves,
telescopic runners
If lightly soiled, wipe with a soft cloth, warm water and washing up liquid. For more
stubborn marks soak in warm water and washing up liquid and clean with a nylon
scourer.
The side shelf runners and shelves can be cleaned In a dishwasher.
This is not advisable with the telescopic runners as the detergent may remove the
lubrication on the runners.
Removing and refitting the telescopic runners
- The telescopic runners fit any shelf level, and work with both the grill tray and
wire shelves.
-
Locate the two spring clips at the front and back of the runners.
-
Gently pull down the front spring clip.
-
Pull the runner away from the oven side - be careful not to strain the clip.
-
Repeat steps 2 - 3 on rear spring clip to remove runner.
-
To replace, hold runner level with front section of side support and clip in place.
Repeat with rear section.
Summary of Contents for her series
Page 44: ...44 ...
