EXPRESS DUAL 3000MC
© Bernhard and Company Limited
22
8. Maintenance
8.1
Grinding Wheel Replacement
NOTE
Grinding wheels should always be fitted by competent, trained personnel.
8.1.1 The grinding wheel (stone) is held on the carrier by a nut which should be loosened, using
the “C” Spanner provided, before the assembly is removed from the mainshaft.
8.1.2 Slide the grinding wheel to the left hand side of the machine (viewed from the operator
position).
8.1.3 Raise the mainshaft to its maximum height, maintaining the shaft as horizontal as possible
until the right hand side comes up against the stop in the feed column and the left hand
side is at its maximum height. At this point the fork will drop away from the grinding wheel
assembly.
8.1.4 Place a wooden block under the mainshaft to the right hand side of the grinding wheel
assembly, bridging the front bed and front channel to take the weight of the mainshaft
when the side arm is removed (see Fig. 8.1.4).
8.1.5 Release the 2 allen screws in the bearing flange ring on the left hand end of the main
shaft.
8.1.6 Remove the circlip retaining the left hand side arm to the rear shaft. The side arm can now
be removed from the machine.
Fig: 8.1.4
Summary of Contents for EXPRESS DUAL 3000MC
