41
Standard Buttenhole
Stitch pattern:
Mode 1 :
0
Mode 2 :
10
Thread tension:
1 - 5
Presser foot:
Buttonhole foot with slide
Buttonhole lever sign
•
To sew
Press the needle stop up/down button to raise the needle.
Attach the buttonhole foot with slide R snapping the pin
into the notch of the presser foot holder.
Notch
Pin
PLEASE NOTE:
If the button is extremely thick, make a test buttonhole on
an extra piece of the fabric.
If it is dif
fi
cult to
fi
t the button through the test buttonhole,
you can lengthen the buttonhole by pulling the button
holder back a little. The length of the buttonhole will be
increased.
Pull the button holder to the back, and place the button
in it. Push it together tightly against the button.
Pull the buttonhole lever down as far as it will go.
Buttonhole lever
Insert the corner of the fabric under the foot. Press the
needle stop up/down button twice. Remove the fabric to the
left to draw the needle thread through the hole of the foot.
Place the fabric under the foot, and lower the needle at the
starting point of the buttonhole mark . Then lower the But-
tonhole foot with slide.
Buttonhole mark
Starting point
Button holder
Extra gap
PLEASE NOTE:
Make sure that is no gap
between slider and stop-
per.Otherwise the buttonhole is not sewn properly.
Slider
Stopper
No gap
Sewing gap
