Sewing preparation
22
2020-09 EN 5220105.00A.04
> Raise the presser foot.
NOTICE
Needle breakage caused by incorrect presser foot
If the presser foot is not suitable for the selected stitch, the needle may collide with the presser foot and
break.
> Always use a presser foot that is suitable for the stitch.
> Position the new presser foot sole under the notch in the shaft (1) so that the notch in the shaft is
positioned above the presser foot sole pin (2).
> Carefully lower the presser foot lifter until the notch in the shaft engages with the presser foot sole pin.
1
2
Removing and inserting the presser foot holder
Prerequisite:
•
The presser foot sole is removed.
> Raise the presser foot.
> Align the presser foot holder (1) with the presser foot bar (2) underneath and to the left.
> Hold the presser foot holder firmly and screw in the screw by hand.
> Tighten the screw using the screwdriver.
1
2
Inserting the edge/ quilting guide
The seam guide is suitable for sewing parallel lines.
> Insert the seam guide (1) into the hole in the presser foot holder (2).
> Set the required distance to the adjacent seam.
1
2
2
