FIGURE 5 - Suspension With Back Adapter
FIGURE 3 - Wall Mounting Plate, Wall Marking
A.
PREPARATION
1.
The Architectural Elite 8 Air Curtain is pre-assembled
with four 5/16” shoulder bolts on the back of the unit
(opposite the perforated intake grill).
2.
Position and center the mounting plate over the
door opening with the larger opening of the key
hole slots facing up.
See Figure 3.
3.
Drill the four holes as marked on the wall and
attach the mounting plate with anchors (if used)
and the four mounting screws (provided by
others).
B.
ATTACHING THE AIR CURTAIN TO THE MOUNTING PLATE
1.
Raise the air curtain with the discharge opening
facing down toward the floor. While holding the
unit level, slide the heads of the shoulder bolts
into the larger hole of the key-hole slots of the
mounting plate.
2.
Lower the unit into place, keeping both ends level,
allowing it to rest flush with the mounting plate.
See Figure 4.
3.
After the unit is securely attached to the mounting
plate, re-install the two (2) locking screws at the
bottom corners.
4.
Do not install the perforated intake grill or the
louvered discharge grill at this time.
5.
Proceed to Section V -
ELECTRICAL CONNECTIONS.
III. WALL MOUNTING
IV. SUSPENDED MOUNTING
A. For top mounting using suspension rods, four (4) factory
installed 5/16” threaded inserts are located on the top of
the unit.
See Figure 5.
B.
Install 5/16” threaded rods, or other suitable hardware at a
location sufficient support the Air Curtain. The mounting
hardware (supplied by others) must be capable of support-
ing a minimum of three times the net weight of the
Air Curtain.
See Weight Chart, Table 1.
C. BACK DECORATIVE ADAPTOR – if the air curtain was
ordered with a back adaptor, install the adaptor at this
time. A maximum of 6” between the wall and intake grill
is required.
See Figure 5.
D. Attach 5/16” threaded rods, or other suitable hardware to
the top mounted threaded inserts.
E.
DO NOT install the perforated intake grill or the louvered
air discharge grill at this time.
F.
Proceed to Section V -
ELECTRICAL CONNECTIONS.
FIGURE 4 - Mounting to Wall Plate
- 5 -
NOTE: Mount large hole
of keyhole slots on top
AIR CURTAIN
DISCHARGE
GRILL
FLUSH FIT
FLUSH FIT
