Berkeley S.A.E., Installation, Repair, And Operating Instructions, Page: 22 / 28

I. QUARTERLY INSPECTION
Inspect all system piping connections for leakage
or possible misalignment.
Complete any lubrication requirements as dictated
by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible
replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Check pump bearings from signs of wear. Repack
or replace as necessary.
Check alignment of flywheel coupling.
________________________________________
________________________________________
________________________________________
II. QUARTERLY INSPECTION
Inspect all system piping connections for leakage
or possible misalignment.
Complete any lubrication requirements as dictated
by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible
replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Check pump bearings from signs of wear. Repack
or replace as necessary.
Check alignment of flywheel coupling.
________________________________________
________________________________________
________________________________________
NOTES:
III. QUARTERLY INSPECTION
Inspect all system piping connections for leakage
or possible misalignment.
Complete any lubrication requirements as dictated
by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible
replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Check pump bearings from signs of wear. Repack
or replace as necessary.
Check alignment of flywheel coupling.
________________________________________
________________________________________
________________________________________
IV. QUARTERLY INSPECTION
Inspect all system piping connections for leakage
or possible misalignment.
Complete any lubrication requirements as dictated
by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible
replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Check pump bearings from signs of wear. Repack
or replace as necessary.
Check alignment of flywheel coupling.
________________________________________
________________________________________
________________________________________
ANNUAL INSPECTION
Inspect pump and entire pumping system for signs
of wear.
Inspect system valves, screens, etc.
Check pump impeller and balance ring for
clearance.
Inspect impeller, volute case, and seal chamber for
signs of excessive wear or corrosion.
Page 22 F00636
Routine Inspection
Maintenance
Record