10 • PM30 & PM40 O
WNER
/O
PERATOR
M
ANUA
L
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
C
LEANING
AND
S
ANITIZING
The Models PM30 and PM40 mixers have been designed for a minimal amount of owner mainte-
nance.
After use, thoroughly clean the bowl and attachments with hot soapy water. The mixer housing can
be wiped down with a damp cloth. Rinse, sanitize and allow to air dry.
When sanitizing be sure to use only an approved sanitizing solution. This will help kill germs and
bacteria.
If accessories have been used (example: VSPH) apply some Berkel USDA approved food equipment
oil to the auxiliary drive socket and accessory shafts for lubrication.
WARNING
Use only USDA-authorized Berkel oil or grease to prevent possible food contamination.
For your convenience, this oil is supplied in the following quantities: 2 oz. (part # 4675-00182),
16 oz. (part # 4675-00183), or one gallon (part # 4675-00184) containers.
The grease is supplied in a pack of three 3-ounce tubes (part # 4675-00185).
T
ROUBLESHOOTING
If your mixer should fail to function, there are a few things you can check before calling a service
technician. If you do need service, visit our web site at
www.berkel.com
. Pull down the service tab
and click on your state. A list of the Designated Berkel Service Locations will be shown.
Motor will not operate when “start” toggle button is moved
•
The mixer is overloaded, activating the thermal overload switch. Correct the situation causing
the overload by reducing the load or reducing mixing speed. See the product capacity chart on
page 13.
•
Turn the timer past “0” or to the “hold” position for manual operation. The mixer will not
operate when the timer is at the “0” position.
•
The bowl guard is not in place. Rotate the bowl guard fully to the right.
•
The bowl is not fully up and in place. Lift the bowl to its fully up position.
Motor operates, but planetary does not turn in any of the 3 speeds
•
Internal drive or transmission linkage is inoperative. Contact your nearest Designated Berkel
Service Location.
Hard to shift speeds
•
Make sure the shift lever is fully engaged.
