4.11 Changing the network settings
Note
Most of the steps in the procedures outlined in the following section are performed on
and with the operator panel firmware which has been developed by the manufacturer.
Therefore, the steps or the availability
on the firmware version. Carrying out any of the following procedures or changing
other firmware settings requires specialized knowledge of computer science and
automation. Therefore, the compressor manufacturer
manipulating the firmware settings, and is not responsible for the consequences of
changes to the firmware settings, or any other changes made using the firmware
tools.
To change the network settings of the PLC, use the following
•
Change the network parameters in the parameters 1 on the screen 2
in Fig. 9.
•
Confirm the settings by clicking the V button next to the para
2-9-7.
•
Close the operating system using the parameter 3 on the screen 2
further procedures.
Ustawienia sieciowe sterownika PLC
To change the network settings of the HMI operator panel, use the following procedure:
•
Close the operating system using the parameter 3 on the screen 2
•
Click on Settings in Start Center.
•
Click on Network Interface in the Transfer, Network & Intern
•
Set the new network parameters.
User Manual_S7-1200 compressor controller
Changing the network settings
Most of the steps in the procedures outlined in the following section are performed on
and with the operator panel firmware which has been developed by the manufacturer.
Therefore, the steps or the availability of each of the procedures may vary depending
on the firmware version. Carrying out any of the following procedures or changing
other firmware settings requires specialized knowledge of computer science and
automation. Therefore, the compressor manufacturer does not recommend
manipulating the firmware settings, and is not responsible for the consequences of
changes to the firmware settings, or any other changes made using the firmware
To change the network settings of the PLC, use the following procedure:
Change the network parameters in the parameters 1 on the screen 2
Confirm the settings by clicking the V button next to the para
Close the operating system using the parameter 3 on the screen 2
further procedures.
Ustawienia sieciowe sterownika PLC -
Controller network settings
Maska -
Mask,
Bramka -
Gateway
Fig. 9View of the IP settings screen.
To change the network settings of the HMI operator panel, use the following procedure:
Close the operating system using the parameter 3 on the screen 2
Click on Settings in Start Center.
Click on Network Interface in the Transfer, Network & Internet group.
Set the new network parameters.
27
Most of the steps in the procedures outlined in the following section are performed on
and with the operator panel firmware which has been developed by the manufacturer.
of each of the procedures may vary depending
on the firmware version. Carrying out any of the following procedures or changing
other firmware settings requires specialized knowledge of computer science and
does not recommend
manipulating the firmware settings, and is not responsible for the consequences of
changes to the firmware settings, or any other changes made using the firmware
procedure:
Change the network parameters in the parameters 1 on the screen 2-9-7, as shown
Confirm the settings by clicking the V button next to the parameters 1 on the screen
Close the operating system using the parameter 3 on the screen 2-3 and carry out
Controller network settings
To change the network settings of the HMI operator panel, use the following procedure:
Close the operating system using the parameter 3 on the screen 2-3.
et group.
