BERG Toys Compact Cyclo, User Manual

Page: 16 / 80

with oil, grease and fuel. Make sure that the tyre valve caps are always in place on the
valves.
EN
5.3 Steering
The steering mechanism must be checked every month on the following points:
•
Breakage, wear and / or damage to all parts of the steering mechanism.
•
The bolts are firmly in place.
•
Check X = Y-5mm (see Fig 5.1).
I
II
Y
X
X=Y-5mm
17
5
Fig. 5.1
5.4 Drive mechanism
5.4.1 Chain
The chain must be greased regularly to keep it running smoothly. if the chain is too
taut, the pedal go-kart will be heavy to pedal and there is also a good chance that the
chain will break. If the chain is not tight enough, it will easily jump off the teeth on the
gear wheel and the chain case may also be damaged. The process for tightening the
chain is described below.
To tighten the chain:
Loosen the nut and bolt a little and then tighten the chain with the nut. Then tighten the
nut and bolt again.
> 30 Nm22ft.lbs
Fig. 5.2
IMPORTANT: Do not allow the chain to be too tight. Remove the lower half of the chain
case to see how taut it is. It should be possible to push the chain down easily by 2cm in
the centre.
Sheet nr. 49.90.61.00 Sheet nr. 49.90.61.00 Sheet nr. 49.90.61.00 Sheet nr. 49.90.61.00 Sheet nr. 49.90.61.00 Sheet nr. 49.90.61.00 Sheet nr. 49.90.61.00