Assembly & initial set-up
10
Un-hook driveline from tractor PTO shaft and pull outer
and inner drivelines apart.
Reattach outer driveline to tractor PTO shaft. Pull on
inner and outer drivelines to be sure universal joints are
properly secured.
Hold inner and outer drivelines parallel to each other:
Make sure dimension “D” is at least 1”.
If needed:
a. Mark driveli
nes halves at the correct length (“C”) to
cut.
b. Remove drivelines halves from tractor and gearbox
shafts.
c. Remove the driveline guards.
d.
Cut the “inner and outer drivelive tubes” off the same
required length (distance C).
e. Deburr edges of the drive tubes that were cut with a
file and remove all filings from the tubes.
f.
Cut the “inner and outer drivelive guards” off the same
required length (“C”)
.
A.
Grease the internal driveshaft tube.
B.
Reinstall the guards.
Assembly options
Please see your dealer for a complete list of updated
options.
Extended wings kit w/ snow drift
cutters
Please see instructions included in the kit.
Snow drift cutters kit
Please see instructions included in the kit.
Initial set-up
Please see adjustment section for the entire settings and
make sure the validation of the PTO drive shaft have
been made (see section assembly and initial setup).
D
Summary of Contents for 700980-1BER
