4
ASSEMBLY
STEP 1
INSTALLATION OF THE ELECTRIC
ROTATION KIT ON THE COMPACT
SNOWBLOWER:
Dismount the rotation worm (item 1), the chute (item 2)
and the rotation ring (item 3) if already installed.
Dismount the chute
Install the bracket (item 1) under the base of the chute
(item 2) by inserting the welded bolt in the rotation worm
support (item 3) and secure with a 3/8" flange nut.
Place the angled part completely against the wall at the
base of the chute and under the chute’s rotation ring.
Hold in place with a pair of vice grips. Using the bracket
as a template, drill two holes 9/32" in the base of the
chute.
Secure in place with two 1/4 x 1/2" hex bolts and flange
nuts (heads inside).
Insert the plastic bushing (item 4) in the sleeve (item 5).
Tighten the bolts firmly.
Install bracket
Apply some grease on the end of the rotation worm’s
shaft and insert into the sleeve.
Install the assembled motor (item 1) under the bracket
(item 2) with two 1/4 x 1/2" hex bolts and flange nuts.
Tighten the screws firmly.
Install the motor