Bercomac 700413-5, Owner'S Manual, Page: 25 / 40

23
ASSEMBLY
Attach the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the springs (item 4).
Lift the snowblower by pulling the lift arm. Turn the
tension arm (item 1) towards the back. Hook the
chain (item 2) (of the helper spring) on the tip (item 3)
of the left support intended for this purpose. Turn the
tension arm towards the front to apply tension on the
spring.
Lower the snowblower.
STEP 4
SNOWBLOWER INSTALLATION:
Refer to snowblower owner’s manual, parts breakdown
section for parts identification.
WARNING
FOR YOUR SECURITY:
Read the snowblower’s owner's manual for safety
precautions and rules.
Follow the assembly and operation instructions.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
CAUTION
The belt tension arm and lift assist spring are
spring loaded & needs to be held firmly while
displacing to prevent injury
.
NOTE: See belt installation instructions in the
maintenance section of the snowblower owner’s
manual.
Install snowblower and lift assist spring
CAUTION
Never use the snowblower without the belt guard.
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.