Bercomac 700413-5, Owner'S Manual, Page: 11 / 40

9
RIGHT SUPPORT:
Install the right support (item 1) on the right side.
The chart identifies the hardware according to the
holes in the tractor’s frame. Even though some holes
may not exist on certain models of tractors,
use the
maximum of holes & bolts possible to ensure the
solidity of the kit.
Carr. B. = Carriage bolt; head towards the inside.
Hex B. = Hexagonal bolt; head towards the outside.
N/A = Not applicable
Install right support .
ASSEMBLY
NOTES :
1. On new tractors, turning the wheels to the left will
facilitate installation.
2. The spacer (item 15) is used to strengthen
certain heat shields.
If necessary, slide the shim (item 14) between the
tractor frame (item 16) and the right support; in line
with hole (item 9 or item 11). (Make sure that the shim
stays perpendicular with the top of the support).
Do not tighten the screws or the nuts.
2 Carr. B 3/8 x 3/4’’
Flange nut 3/8’’
Thread cutting
screw 3/8 x 1’’
3 N/A Thread cutting
screw 3/8 x 1’’
4 N/A Thread cutting
screw 3/8 x 1’’
5 Carr. B. 5/16 x 1’’
Flange nut 5/16’’
N/A
6 N/A Thread cutting
screw 5/16 x 1’’
7, 9 Hex B. 3/8 x 1’’
Flange nut 3/8’’
N/A
10, 11 N/A Hex B. 3/8 x 1’’
12 Set screw 5/16 x 1/2’’
(on support for the
cab)
N/A
Item # If square holes on
tractor
If threaded holes
on tractor
13 Tractor bolt and
Spacer (Round hole)
N/A
8 Hex B. 3/8 x 1’’
Flange nut 3/8’’
Thread cutting
screw 3/8 x 1’’