Berbel BKH 120 FO, Operating And Installation Instructions

Page: 23 / 36

23
Operation
6005044_0 – 04.12.2019
EN
4.2.6 Run-on function
The device comes with a run-on function. When the function
is used, the device continues to work 10 minutes after being
switched off.
In recirculated air mode, it is necessary to use the run-on
function so that the device can remove the remaining
odours. Using the run-on function increases the life of the
filter filling. The filter filling must be replaced at regular
intervals.
The run-on function can be switched on manually or
automatically. The device is delivered with the automatic run-
on function active, and settings are made in configuration
mode.
D “4.3 Configuring the device” (page 24).
Button Function
The device is switched on.
If the automatic run-on function is activated:
☞
Touch the button one time.
y
The device switches off.
y
The run-on time (10 minutes) starts
automatically in power level 1.
y
The button for power level 1 goes on.
y
The run-on function button flashes.
y
It is possible to switch between the power
levels.
If the button is touched again, the device
shuts off completely.
The device is switched on, and any power
level is selected.
☞
Touch the button one time.
y The run-on time (10 minutes) starts in the
selected power level.
y The button for the active power level lights
up.
y The run-on function button flashes.
y It is possible to switch between the power
levels.
If the button is touched again, the run-on
function stops.
4.2.7 AutoRun
Devices equipped with the AutoRun module start
automatically when the cooktop is turned on. When the
cooktop is turned off, the device switches to run-on function
and then switches off.
The AutoRun automation is set in configuration mode.
D “4.3 Configuring the device” (page 24).