73
Installation
EN
6002782_b – 14.09.2016
☞
Make sure that the legal safety clearances will be
complied with:
y
Recommendation 400 mm.
y
With gas hobs, at least 650 mm.
D
WARNING
Hazard due to explosions or electric shock.
Drilling through gas, water or electrical lines can lead to
hazardous situations.
☞
Ensure that there are no lines in the ceiling at the
fastening points.
Ø 8
65
☞
Determine the locations of the fastening points and mark
them:
y
2 bolt anchors inside the lock holes.
y
2 bolt anchors in the centre of slots.
☞
Drill the holes in the ceiling.
☞
Insert the bolt anchors into the holes.
☞
Ensure that the bolt anchors are tight in the holes.
6
☞
Screw the nuts and the washers onto the bolt anchors in
the position of the lock holes.
☞
Ensure that there is at least a 6 mm gap between the
ceiling and the top edge of the washers.
☞
Push the ceiling mounting plate over the nuts in the lock
holes.
☞
Twist the ceiling mounting plate so that it is held by the
nuts.
☞
Ensure that the ceiling mounting plate is hanging
securely.
☞
Screw the nuts and the washers onto the bolt anchors in
the slots.
☞
Ensure that the ceiling mounting plate is aligned parallel
to the hob’s front edge.
☞
Tighten the nuts cross-wise using the spanner.
☞
Ensure that all nuts are fully tightened.
The ceiling mounting plate is hanging securely and aligned
correctly on the ceiling.
Summary of Contents for BDL 115 SK
Page 92: ...6002782_b 14 09 2016 ...
