BEPOWEREQUIPMENT 85.403.003, User Manual, Page: 5 / 48

5
Pre-Operation Instructions
1. Remove Whirl-A-Way from packaging. Ensure there is no damage and that
rotary arm freely spins by hand.
2. Connect Whirl-A-Way to the end of the high-pressure hose. The high-pressure
hose will need to have 3/8” quick connect coupler to attach to the 3/8” quick
connect plug on the Whirl-A-Way.
3. Prepare your pressure washer for start-up as per its start-up procedure found its
manual.
4. Once water is connected to the pressure washer, squeeze the trigger of the spray
wand to ensure that water flows through the whirl-a-way.
5. Level the Whirl-A-Way onto a flat surface.
6. Start the pressure washer as instructed in its manual.
Operating Instructions
1. Walk slowly behind the Whirl-A-Way moving it in a rhythmic side-to-side
motion.
2. If striping or swirling occurs then slow your pace.
3. If striping or swirling continues then it is likely the nozzles are clogged or
damaged. If they are damage you will see visible deformation of the nozzle from
impact. If there is no damage, then they need to be cleaned. See the Nozzle
Maintenance section for details.
4. When done working, always flush with clean water. Detach from your pressure
washer and drain out any water to prevent possible freezing damage. Store in a
manner so not to deform the bristle skirt.
Intended Use
1. The Whirl-A-Way is designed to rapidly clean large, flat surfaces such as concrete
floors.
2. It is not intended to clean rough or uneven surfaces such as stairs. Uneven surfaces
can cause damage.
3. The pressure washer must be rated to make the Whirl-A-Way operate properly. For
the standard nozzles that come with the Whirl-A-Way the pressure washer must
have the following.
• 3/8” Quick-connect coupler on the end of the high-pressure hose
• 1,500 - 4,000 PSI rating / 5,000 for 85.403.008 Model
• 3.0 - 5.0 GPM rating
OPERATING INSTRUCTIONS