Assembly
Page 17
Air Rower
Raise the back of the Main Rowing Rail or turn the Artemis Air Rower
on its side and attach the Return Chord (36) from inside the Main
Rowing Rail to the Drive Strap (34) passing it through the back of the
Main Frame, using the Drive Strap - Cord Clip (35) that is pre-fitted to
the end of the Return Chord. (see figA).
Ensure that the Drive Strap (34) exits the Drivewheel (30) from the
TOP as damage or failure may occur due to friction on the frame or
fixing bolts.
Connect the Exercise Monitor Link Cable (21) to the Seat Sensor
Cable (22) ensuring that the contacts are pushed fully home. (You will
hear / feel 2 clicks indicating that correct contact has been
made).(see figD)
Lower the assembled Rowing Rail or sit the rower flat and secure in
place with 1 x M8 Large OD Flat Washer (49) and the Rowing Rail
Pivot Knob (14), tightening securely. Note: - It is imperative that the
Large OD Flat Washer is fitted before using your Artemis Air Rower.
4
36
37
1
2
22
21
30
34
49
14
36
34 35
FWD
Before fitment, ensure that the
Drive Strap (34) is wound
around the Drive Wheel (30) for
2 full rotations as this will ensure
correct return strength of the
Row Grip (see fig B)
Please ensure that the Return
Chord (36) is situated in the
centre of the Return Chord
Pulley (37) at the rear of the
Main Rowing Rail before finally
connecting the Drive Strap and
Return Chord together.
(see fig C)
Note
Note
fig A
fig B
fig C
fig D