Bentone B 55-3R, Installation And Maintenance Instruction

Page: 28 / 52

28
Bentone
6.3 Replacing the damper motor
Removal and fitting
1. Turn off the main power switch and disconnect the Eurostecker
connectors from the burner.
2. Note the positions of the cables and then disconnect the cables from
the damper motor.
3. Release the damper motor and lock it at 30°.
4. Undo the screws (G) that secure the mounting plate for the damper
motor.
5. Raise it carefully so that the air damper stays in the air intake.
6. Disconnect the (E) link arm from the motor shaft.
7. Separate the damper motor from the mounting plate (I).
8. Refit the damper motor on the mounting plate.
9. Connect the link arm to the damper motor shaft. It is important that the
screw is at right angles to the plane of the shaft.
10. Release the damper motor and lock it at 30°.
11. Fit the mounting plate by guiding the link arm into the attachment point
on the air damper and the air damper shaft into the mounting plate
(make sure that the bushings are fitted between the mounting plate
and damper shaft).
12. Release the damper motor and check that the damper moves freely.
Close the damper and zero the graduated scale on the damper motor.
13. Make the electrical connections to the damper motor.
14. Reset the damper motor cams.
15. Connect the Eurostecker connectors and turn on the main power
switch.
16. Check combustion.
! When resetting
dampers, ensure
that they do not
engage in the
close damper
position. If dampers
do engage, the
automatic control
unit will report an
error message.
E
G
I
G
165 205 36 2020-11-02/3
!
When servicing/replacing components that affect combustion, an analysis and
soot test must be carried out on the installation.