25
Bentone
5.6 Hydraulic air adjustment
Stage 1
Set the control switch (S2) to low load (I). Undo the screw (E), turn the
damper to the desired position and retighten the screw (E).
Stage 2
Set the control switch (S2) to high load (I). Use the adjuster pin to screw the
sleeve (F) in (to reduce) or out (to increase). The position of the dam-per can
be read from the damper scale (G). Carry out flue gas analysis to check the
air settings
5.7 Air setting
When the burner’s power stage has been selected, check the setting values
for air dampers in table (3.6, 3.7). Read the damper angle for each of the
power stages This must then be used when the settings are made in the
burner’s control system (se punkt 3.3)
Check the air settings by conducting a flue gas analysis.
E
F
G
Summary of Contents for B 55-3R
Page 37: ...37 Bentone 165 305 02 8 Electrical equipment 8 1 Wiring diagram...
Page 50: ......
Page 51: ......
Page 52: ...Enertech AB P O Box 309 SE 341 26 Ljungby www bentone com...
