28
Bentone
165 405 13
7.3
Combustion device
1.
Disconnect the main power and shut off the fuel supply.
2.
Loosen nut (G) and lift fan housing off fi xing fl ange.
3.
Remove brake plate and electrode holder from oil pipe and clean.
4.
Replace nozzle.
5.
Clean or replace brake plate.
6.
Check ignition electrodes, replace if necessary (see Technical data for
adjustment).
7.
Fit brake plate and electrode holder, (see Technical data for
adjustment).
8.
Check fl ame tube and clean if necessary.
9.
Install fl ame tube, be sure to install the drainage hole downwards (not
available on all fl ame tubes) so that any oil spills can drain out.
10. Refi t fan housing and fi xing fl ange, lock with nut (G).
11. Switch on the main power and open the fuel supply.
12. Start burner and check/adjust combustion.
!
Use caution when
operating the burner,
surfaces may be hot.
!
NB: When soiled, always
replace nozzles with new
nozzles. Do not clean.
!
Before obtaining access to electrical and fuel line components
all supply circuits must be disconnected.
G
!
When servicing/replacing components that aff ect combustion,
fl ue gas analysis and soot test must be carried out following
installation.
Summary of Contents for B 30 A
Page 39: ......
Page 40: ...Enertech AB P O Box 309 SE 341 26 Ljungby www bentone com...
