ENGLISH
!
!
!
!
!
250 V
_
_
_
_
_
is present on some parts of
the PCB circuitry of this device. Do not
touch the PCB for at least 2 minutes af-
ter removing the power supply.
!
!
!
!
!
This device is designed to work with
Nickel-Cadmium batteries. When dispos-
ing of used batteries, abide by the Local
laws in force.
General Features
Available with or without back-up battery, with
or without Strobe
3 selectable sound speeds
Tamper detection
Universal Wall mount bracket
General Description
The Wave HornStrobe is an Audible-Visual Alarm
signalling device for Security Systems.
It is available in four versions, as per the follow-
ing table.
'()*+,-
:3),c(
;/tuv51V;/33()w
7/8(97:;
?@
?@
7/8(97;
?@
7/8(97:
?@
7/8(97
All versions have piezoelectric transducers for
audible signalling, whereas only the Wave/WSB
and Wave/WS versions are fitted with Strobes
for visual signalling.
The Wave/WSB and Wave/WB versions are fit-
ted with 7.2 V – 300 mA batteries (art. CB7203)
for back-up power during blackout.
All versions provide tamper protection against the
removal of the Lid.
Installation Guidelines
Carefully work through the following steps (see
Figure 1).
This HornStrobe is suitable for indoor use
only.
1. Remove the Logo Insert
5
.
2. Remove the screw
4
.
3. Pull the Lid
3
upwards and away from the
backplate.
4. Remove the Lens cover
2
.
5. Using a screwdriver or similar tool, push down
on the locking tab
9
and push the Wall bracket
12
away from the Backplate
10
.
6. Pull the connection wires through the cable
entry
13
.
7. Using anchor screws, secure the Wall bracket
12
to the wall or to the outlet box.
!
!
!
!
!
Be careful to avoid conduits and plumb-
ing when drilling.
8. Pull the connection wires through the cable
entry
11
.
9. Slide the Backplate
10
downwards onto the
Wall bracket
12
until it snaps closed.
10. Select the required sound speed, as per the
instructions in the relevant section.
11. Complete the connections on the terminal
board
7,
as per the instructions in the rel-
evant section.
12. Replace the Lens cover
2
.
13.
For
Wave/WSB
and
Wave/WB
only:
locate
the battery
6,
as per Figure 1, then connect it
to the input
J5
.
!
!
!
!
!
For
Wave/WSB
and
Wave/WB
only:
before
connecting the battery, ensure that: the
Posi-
tive Voltage
(12 V)
is present on terminal
+B
;
the
Positive Voltage
(12 V)
is present
on terminal
+N
or
jumper J3
is connected;
Ground
is present on
–A
.
14. Snap the top of the Lid
3
onto the Backplate
10
, then push the bottom part onto the
backplate posts.
15. Replace the Closure screw
4
.
16. Replace the Logo Insert
5
.
