Bentel Security Academy8L, Manual

Page: 6 / 12

INSTALLATION
Mounting the Panel
The Panel should be located in a dry area, preferably near the mains
power source and incoming telephone line.
Follow the installation instructions carefully, and refer to
figure 1
.
Step 1
Unfasten the screws
(1)
and remove the front.
Step 2
Check for cable conduits and water pipes before drilling. Use the back box
as a drill pattern
(
holes
3)
.
Step 3
Attach the NCDUEVOX voice board 8 (if used).
Step 4
Pull the wires through the hole
(10)
and mount the back box.
Terminal board
Below is a description of the Main Unit terminal board, keypads and key
readers.
Ø
The
Terminal
column shows the terminal number and the identifier of each
terminal (in square brackets).
Ø
The
DESCRIPTION
column provides a description of each terminal.
The
V
column shows the voltage on the corresponding terminal.
The
I
column shows the maximum current for each terminal.
Where
(1)
or
(2)
is shown as the value in the
I
column refer to the footnote
below the terminal description table.
6
Security System Control Panel
Academy8L