NCDUEVOX voice board
How to attach the NCDUEVOX voice board
Disconnect the Mains and battery before attaching the NCDUEVOX board
to a Panel that is in service.
Step 1
Slot the NCDUEVOX voice board into its holder----microphone to the top.
Step 2
Connect the NCDUEVOX cable
(40)
to the connector
(4)
on the Main Unit
board.
Step 3
When the NCDUEVOX is properly attached----complete the connections
then power the Panel, and record the alarm messages, as per the instruc-
tions in the
INSTALLATION MANUAL
.
The optional OmniaVox-MS and Speaker will allow Remote Listen-in on
ambients, other than that of the Panel. Locate the OmniaVox-MS and
Speaker as required then complete the connections with the Voice Board
(use shielded cable only). Refer to the Installation Manual.
ISTUCBLEACADEM8L 0.1 280601 V4.2 BUUC
Figure 3
Attaching the NCDUEVOX board
Summary of Contents for Academy8L
Page 1: ......
Page 4: ...Figure 1 Parts 4 Security System Control Panel Academy8L...
Page 10: ...Figure 2 A Typical System...
Page 11: ...INSTALLATION 11...
