Bentel Security Academy8L, Manual

Page: 5 / 12

PARTS
The table below provides a brief description of each part (the numbers in
boldface refer to the parts illustrated in the
figure 1
), and the meaning of
the
ON / OFF
status of each indicator
LED
.
PARTS DESCRIPTIONS
1 4 screws
2
5 Indicator LEDs
3 4 holes (Ø 5 mm)
4 NormVox2 voice board connector
5 Protection fuse for sensor and auxiliary power supply (250 V - 5 A)
6
Protection fuse against polarity inversion on battery (250 V - 8 A)
7 DB9 connector for PC connection via serial cable
8-8a Tamper microswitch; 8a optional (see Installation Manual page 26)
9
Connector for the 3 A switching power supply BAQ35 or BAW35
(optional)
10
3 holes for wires (Ø40 mm)
11
Mains connection terminals (230 V~
±
10% / 150 mA)
12 Housing for 13.8 V / 7 Ah standby battery (optional)
13
Service mode jumper. Connection of this jumper will disable the Alarm
outputs for maintenance purposes.
14 Battery connectors
15
Firmware Release: to be communicated to Service dealer
LEDs STATUS
ON:
OFF:
Panel powered from mains
Mains failure----Panel powered by the battery
OFF:
ON:
Battery
OK
Battery low or battery trouble
OFF:
ON:
Fuse
5
intact (power to sensors)
Fuse
5
blown
OFF:
ON:
Communicator in standby status: telephone line free
Telephone line engaged by the communicator
OFF:
ON:
Communication bus
OK
Communication bus trouble
PARTS
5