BENRUBI IZZY PG-900, Instruction Manual

Page: 29 / 34

28
Shaving with the micro-shaver
• Use the microshaver to crate smooth, well-defined contours.
• Before you use the microshaver, always check it for damage or wear. If the foil or cutter
is damaged or worn, do not use the microshaver, as injury may occur. Replace the whole
attachment before you use the microshaver again.
1. Pre-trim the contours you want to shave with the full size trimmer (1) (without cutting guide)
or the precision trimmer (3).
2. Attach the micro-shaver (5) on the body of the device.
3. Press the On/off switch (12) and gently press the micro-shaver onto the skin at a 45° angle
and shave along the contours to remove the hairs (Fig.22).
Do not press too hard!
4. When shaving is complete, press the on/off switch (12) again.
5. Remove the micro-shaver.
6. Clean the micro-shaver and the device before storing it (see "Cleaning and care").
Tips for better results:
• Move the device with controlled movements to shave your beard or your mustache.
• Use your free hand to stretch your skin. This helps the hair stand up, making it easier
to shave.
• The micro-shaver is designed to shave detail around beard/mustache/sideburns. It was
not designed to shave the entire face.
Body trimming with body hair trimmer & vertical trimming comb
• Use the body hair trimmer to shave the back, chest area even to trim your beard or
mustache and remove single hairs.
• Trimming with body hair trimmer results in very short hair (0.6mm).
1. Attach the body hair trimmer (2) to the body of the device.
2. Turn on the device by pressing the On/Off switch (12) and gently touch the hair with the body
hair trimmer and take careful and controlled movements (fig.23-24).
3. When you have finished shaving, turn off the device by pressing the On/Off switch (12).
4. Remove the body hair trimmer.
5. Clean the body hair trimmer and the appliance before storing it (see "Cleaning and care").